Table of Contents
Advertisement
Self-Timer
Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way
adding the final touch to a memorable picture.
1
SELECT OPERATION MODE
Turn the Power Dial to "
down the lock button located on the dial.
2
PULL OUT VIEWFINDER OR OPEN
LCD MONITOR
Pull out the viewfinder fully or open the LCD
monitor to approx. 90 degrees. The Self-Timer
indication appears.
•The camcorder enters the Record-Standby
mode.
•You can tilt the LCD monitor upward to 180
degrees so that it faces forward and view
yourself while self-recording (with the
viewfinder pushed back).
3
ENGAGE SELF-TIMER MODE
Press START/STOP.
After 15 seconds, the beep sounds and
recording begins.
START/STOP button
Lock button
Power lamp
When the START/STOP button
is pressed, the tally lamp
changes as shown below:
Begins blinking
(Self-Timer starts)
" while pressing
MANUAL
Self-Timer indication
Power Dial
MANUAL
¥
Blinks quickly
(Self-Timer shooting
starts soon)
After approx. 15 sec.
4
STOP SELF-TIMER RECORDING
Press START/STOP.
•The camcorder re-enters Record-Standby
mode.
5
END SELF-TIMER RECORDING
Set the Power Dial to the " ", " " or "OFF"
position.
•When turning to "OFF", it is not necessary to
press down the lock button.
To Take A Snapshot In The Self-Timer Mode . . .
.... in step 3, press SNAPSHOT instead of
START/STOP. After 15 seconds, a 6-second still
is recorded. After that, the camcorder enters the
Record-Standby mode.
27
EN
Display
– – –
PAUSE
After 15 sec.
REC
444
During recording
¥
Stops blinking
and stays on
(Self-Timer
shooting starts)
4
Advertisement
Table of Contents
