Supporting The Unit - JBL MR-165 Quick Reference Manual

Supporting the unit

1. UNIT
2. HALF SLEEVE
3. HEX NUT
4. LOCK WASHER
5. PLAIN WASHER
6. BODY
7. REAR SUPPORT STRAP
8. TAPPING SCREW
9. M5 X 20 HEX BOLT
Accessories subject to change without notice.
1. Fuse replacement
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after
the replacement, there may be an internal malfunction. In this case, consult your nearest dealer.
2. Warning
Use the specified amperage fuse for each lead.
Use of a higher amperage fuse may cause serious damage.
5
Radio Section Operation
1 2 15
COMPACT DISC PLAYER
MR-165
PWR
MUTE
6
TUN
BD.FN
0.LD MOD 1 2 2
INT INT
16 4 5 7 8
1. Radio Operation
Press MOD button (4) to select Radio mode. Station frequency is indicated on display.
2. To Select Band
Press the BD.FN button (5) to select the desired band
3. Auto / Manual Tuning buttons (6)
Press this button quickly to activate the Auto tuning mode. The unit will automatically seek up
or down the wave band and stop at the next station of sufficient signal strength.
Press and hold tuning button (6) for 2 seconds to enter Manual tuning mode. The unit will seek
up or down the wave band in steps.
4. Station Store function
- Manual Station Store: Select the desired band and tune to a radio station to be memorized.
Choose the preset button (buttons 1-6) into which the station is to be stored, press and hold that
preset button for 2 seconds or until the corresponding preset number is shown on the display.
- Auto Station Store: Press and hold A.PS button (15) for approximately 2 seconds until you hear
a beep sound which confirms the memory function is engaged. The unit will "SEARCH" for six
strong stations and automatically store them on buttons 1-6.
6 stations can be memorized on each of the FM1, FM2, FM3, AM1 & AM2.
5. To Recall the Preset Stations
- Briefly press the preset buttons 1-6 to recall the memorized radio station in that button.
- Briefly press A.PS button (15), the unit will search all preset stations. Each preset can be heard
for 5 seconds. After that the unit will begin searching again. All presets are searched ie- FM1,
FM2, FM3, AM1 and AM2. At your desired preset station, press the A.PS button to stop search.
6. Scan function (13)
In Radio mode, press the SCAN button to scan strong stations. At desired station press the SCAN
button again to stop scanning.
7. Stereo - / mono - reception
The unit automatically receives radio stations in stereo mode if the current station is broadcasting
in stereo; otherwise, mono will be used. The stereo indicator will show on the display if the current
radio station is broadcasting in stereo.
3
HI-POWER 4x45 Watts
14
8.DIS
17
3 4 5 6 7
RPT RDM SCN
AUX
9
10 11 12 13
FM1, FM2, FM3, AM1 or AM2.
10