Fortinet FortiGate-800 Install Manual page 20

LCD and front control buttons
20
To enter an IP address
1 Press Enter to select the interfaces.
2 Press the up and down buttons to highlight the interface you want to configure an
IP address for, and press Enter.
3 Press Enter for IP address.
4 Press the up and down buttons to increase or decrease the number.
5 Press Enter to select the next number.
6 Repeat steps 4 and 5 for all numbers of the IP address.
Use the above steps to configure netmasks and default gateways.
To change the operating mode
1 Make sure the LCD displays the main menu setting.
2 Press Enter to select the interfaces.
3 Press the up and down buttons to highlight the menu, To Bridge Mode.
4 Press Enter to change to Transparent mode.
The FortiGate unit changes to Transparent mode. This may take a few minutes.
5 The LCD should display the following:
Figure 5: LCD showing Transparent mode
Menu [ Fortigat -> ]
Transparent, Standalone
To reset to factory defaults
1 Make sure the LCD displays the main menu.
2 Press Enter to go to the interfaces.
3 Press the up and down arrows to highlight the menu Reset Defaults.
4 Press Enter.
The FortiGate unit resets to factory default settings. This takes a few minutes.
FortiGate-800 and FortiGate-800F FortiOS 3.0MR4 Install Guide
Installing the FortiGate unit
01-30004-0269-20070215