Advertisement
General
Transporting
To safely transport your Revolution, follow the
steps below to prevent damage to your unit.
1
Place protective needle cover over needle.
2
Place the 45rpm adapter on the revolution as
shown below
3
Move the TONE ARM from the ARM REST
and position it over the 45rpm adapter and
align the TONE ARM with the grooves in the
45rpm adapter as shown below.
4
Gently press TONE ARM into grooves on
45rpm adapter.
5
Close the LID and check to make sure it is
secure.
9
Troubleshooting
There is no Power
1
Make sure unit is plugged in correctly.
2
Replace batteries
3
The unit is not turned on: press the POWER
button to ON Position.
There is no Sound
1
Slide the VOLUME CONTROL to raise volume.
2
Check to make sure headphones are not
plugged into the unit.
No signal on FM Transmitter
1
Make sure TRANSMITTER SWITCH is on the
ON position.
2
Make sure the unit and the FM tuner are set
to the same frequency.
3
Check that the distance between the two is 20
feet or less.
4
Remove obstructions to minimize interference.
5
Try moving the Revolution closer to the FM
tuner to reduce signal interference.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
The lighting flash with
CAUTION: TO REDUCE
arrowhead symbol, within
THE RISK OF ELECTRIC
an equilateral triangle, is
SHOCK, DO NOT REMOVE
intended to alert user to
the presence of uninsulated
COVER (OR BACK). NO
"dangerous voltage" within
USER - SERVICEABLE
the product's enclosure
PARTS INSIDE. REFER
that may be of sufficient
SERVICING TO QUALIFIED
magnitude to constitute
risk of electric shock
SERVICE PERSONNEL.
to persons.
Specification
Power source
:
Power Consumption
:
Antenna
:
Speed
:
Speaker
:
Audio output
:
Replacement Needle
:
FM Transmtter Frequency :
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
DO NOT OPEN
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
AC Adaptor AC120V/DC 9V 600mA
6W
Built-in antenna for FM TRANSMTTER
33
1
/
,45 RPM
3
28 x 40 mm 8ohm 2W
600mW
NP4
88.1MHz / 89.9MHz
Advertisement
