Automatic Leveling & Retraction Procedure - FOUR WINDS INTERNATIONAL Chateau 2010 Owner's Manual

Automatic Leveling & Retraction Procedure
Make sure there are no obstructions in the extend or retract paths of the jacks.
Keep all people clear of the recreation vehicle while operating the leveling system.
Do not allow excessive motion in the recreation vehicle during the Auto-Level operation.
This could cause the system to level improperly.
1. TURN ON POWER. The power to the unit must be turned on
before any function can be attempted. You need to have the
ignition key in the OFF position and the parking brake must be
set to turn the control panel on. Push the POWER touch pad
to engage power. The power touch pad should be lit when
power is on.
2. AUTO-LEVEL THE COACH. Press the AUTO-LEVEL touch
pad. The system will automatically level your vehicle.
The control panel will send out a series of beeps to let you know
that AUTO-LEVEL is operating. When completed, the panel will
signal a successful AutoLevel. After ten minutes, the panel will
enter sleep mode.
3. RETRACTING THE JACKS. Your Equalizer System provides
you with the ability to retract the jacks using the ALL RETRACT
feature or the UP touch pads for each jack. Press and release
ALL RETRACT touch pad. All jacks will automatically retract.
The jacks are retracted when all of the LED'S have gone out.
Depending on the vehicle, full retraction may take up to
90 seconds.
NOTE: The null, or level position has been preset at the factory. However, if you want to change
the setting, or if the recreation vehicle has been dormant for more than 60 days you may need to
reset the null. Refer to the automatic hydraulic levelers owner's manual for detailed information
regarding the proper procedures to do this.
FOUR WINDS INTERNATIONAL
Interior Controls & Operations
4-5