Please read this manual before connecting the amplifier. Introduction Your new SOUNDMASTER amplifier has been manufactured from the highest quality components and materials. Please read these instructions carefully and your amplifier will provide many years of service. This amplifier is designed for use in professional high power sound systems and it should be installed by a competent technician as described in the following instructions.
Declaration of Conformity Equipment Soundmaster VF 400 power amplifier Manufacturer M Jay Electronics Limited Address Albion Mills Church Street Morley Leeds LS27 8LY European Standards EN 50 081-1 Emission EN 50 082-2 Immunity EN 60 555 Conducted Emissions EN 60065...
FRONT PANEL FEATURES A.C.Power Switch Peak LED The power switch is a double pole type to If the output of either channel is greater ensure that both the live and neutral than 2dB below the maximum output mains supply is disconnected from the level the peak LED will be illuminated.
Signal Inputs CAUTION - THIS AMPLIFIER MUST CONNECTED EARTH , Each channel can be connected by either FAILURE TO DO SO COULD BE of the XLR type connectors. The female FATAL. and male XLR connector are wired in parallel to enable amplifier inputs to be DO NOT disconnect the green/yellow linked together for large sound systems.
GENERAL DETAILS Service Ventilation This amplifier is a precision piece of To keep the amplifier cool a good flow of equipment, should it require servicing it air is required. If the amplifier is housed should be returned to the dealer or agent in a rack or other enclosed space it is it was purchased from.
Need help?
Do you have a question about the Soundmaster VF 400 and is the answer not in the manual?
Questions and answers