Advertisement
◆
Installation Diagram
◆
Installation Steps
1. Before installation, turn off the electric power, Remove the Head Unit from the dashboard , and find CD Changer port at the back of the Head Unit.
2. Properly connect the wire harness between YATOUR and the Head Unit. If there is an existing CD Changer, the male connector will be used, in this case it must be
connected to the CD changer. Also connect the black Earth cable(if there is) to the metal body of the Head Unit.
3. Turn on the electric power, insert MP3/WMA media device into YATOUR and run the Head Unit, check whether YATOUR works normally.
4. After the successful test, reassemble the Head Unit, put module unit and wire harness in proper place. Then installation is completed.
Remarks:
YATOUR is only fit for vehicles whose Head Unit is equipped with CD Changer Port.
Advertisement
