Dimensional Details - Whirlpool Undercounter Dishwasher Installation Instructions Manual

l-1/2"
HOLE
(A) It is recommended that a three prong ground-
ing type wall receptacle be installed on the
rear wall of the cabinets adjacent to the
opening provided for the dishwasher. See
Figure 3A for details.
(B) Use the dimensions in Figure 3A for locating
the wall receptacle. DO NOT use a female
to male extension cord.
(C) Cut a l-1/2" diameter hole in the lower
rear side corner of the cabinet opening
(within 12" of rear wall) for the cord to pass
through.
(D) If the cabinet side wall is wood, sand the edges
of the hole until smooth. If the side wall is
metal, install a protective grommet to cover
the edge of the hole (supplied in miscellane-
ous parts bag).
(E) Care should be taken when the dishwasher is
installed or removed to avoid damaging the
Dimensional Details
power cord.
LEFT SIDE VIEW
FRONT VIEW
RIGHT SIDE VIEW
25112" -
II I
**
- 23.15116" -
I
Z+C REAR WHEELS IN TOP HOLE
SEE PAGE 7 FOR DETAILS
**TUB FRONT FLANGE
NOTE: With door fully open, the dimension from the top of the door
(in the open position) to the outside rear of the dishwasher tub is 48".
Legend of Designated Items
A
Inlet air-gap
B Water inlet valve connecting fitting
D Electrical junction box
(3/8" Iron pipe size - female)
(OBSERVE ALL GOVERNING CODES AND ORDINANCES)
(l/2" copper tubing - female)
E
Location dimension for water inlet valve connectors
C Drain hose F Water inlet valve
6