Advertisement
INSTALLATION INSTRUCTION
Before Using Your Freezer
• Remove the exterior and interior pack.
• Check to be sure you have all of the following parts:
• 1 Storage Basket
• 1 Instruction Manual
• 1 Plastic Scraper C optional)
• Before connecting the freezer to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
• This appliance is designed to be free standing only, and should not be recessed
or built-in.
• Place your freezer on a floor that is strong enough to support the freezer when
it is fully loaded.
• Allow 15 em of space between the back and sides of the freezer, which allows
the proper air circulation.
• Locate the freezer away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold ambient temperatures may
also cause the freezer not to perform properly.
• Avoid locating the freezer in moist areas.
• Plug the freezer into an exclusive, properly installed-grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3
hours before placing food in the freezer compartment.
Electrical Connection
For your safety please read the following information
OPERATING YOUR FREEZER
• Your freezer has one control for regulating the temperature.
The temperature control is located on the lower right hand corner.
• The range of the temperature control is from position "MIN, MAX and OFF".
Adjust the temperature control to the setting that best suits your needs.
• To turn the freezer off, turn the temperature control to "OFF".
NOTE:
• If the unit is unplugged, has lost power, or been turned off; you must wait 3 to 5
minutes before restarting the unit.
• If you attempt to restart before this time delay, the freezer will not start.
• Large amounts of food will lower the cooling efficiency of the appliance.
• If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize
between adjustments.
Advertisement
