Operating Environment; Remove Pa Tray Spacers - Crown FM500 User Manual

Possible equipment damage!
Before operating the transmitter for
the first time, check for the proper AC
line voltage setting and frequency
selection as described in sections 2.3
and 2.4.
2.1

Operating Environment

You can install the FM transmitter in a standard component rack or on a suitable
surface such as a bench or desk. In any case, the area should be as clean and well-
ventilated as possible. Always allow for at least 2 cm of clearance under the unit for
ventilation. If you set the transmitter on a flat surface, install spacers on the
bottom cover plate. If you install the transmitter in a rack, provide adequate
clearance above and below. Do not locate the transmitter directly above a hot piece
of equipment.
2.2

Remove PA Tray Spacers

The Crown FM 500 is shipped with spacers between the PA tray and the transmitter
back panel. The spacers prevent damage to internal contacts during shipping.
Remove and save the spacers and screws before installing the FM500.
#6
Illustration 2-1 FM 500 PA Tray Mounting Screws
1. Remove screws and spacers from five locations.
2. Firmly push the PA tray into the FM 500 until the PA tray panel touches the
back panel.
3. Locate the bag labeled 500 Hardware. Install four #8 screws and washers and
one number #6 screw and washer. See photo for locations.
2–2
CAUTION
#8
#8
FM500 User's Manual