Front Panel; Rear Panel; Checking Parts - Digital Stream DTX9900 Owner's Manual

Front Panel

G) -:
Channel down
@
+:
Channel up
@
Power: Turn the Converter Box on and off
@
IR Receiver

Rear Panel

G)
ANTENNA IN (75 Ohm) : Connect the outdoor / indoor
@
TV OUT: Connect to television's antenna input.
@
CH 3/4 : Use channel 4 setting unless already in use
by another device.
@
VIDEO: Connect to a TV with this video inputs.

Checking Parts

G)
Remote Control
@AAA15V
. Battery x 2
@ @
@
Power LED When the receiver is powered on, the LED indicator lights
antenna here.
Analog outputs are displayed in 480i (CVBS) format only.
@
Install
tNSTALL
QWNET($
MANUAL GUIDE
@
Owner's Manual
leB@]
green. In standby mode, LED light is red. LED will blink
whenever IR input is detected. LED may blink when the
receiver is entering standby mode. Do not disconnect AC plug
while LED is blinking.
@ @
@
AUDIO UR : When using VIDEO out, connect these tenminals to the
analog audio inputs of a TV set (i.e., to a TV that has
jacks for UR inputs). or, connect these terminals to the
UR inputs of a separate audio component.
@
Power Cable: Connect the AC Power 100-240V into
power source.
@
Guide RF cable
03
G)
@ @
@
Digital to Analog
Converter Box
,
,.