Page 2
Specifications Description Item 68124 Displacement 99cc 310L x 290W x 300H mm Dimensions 12.2L x 11.4W x 11.8H IN. Dry Weight 22 LBS. / 10 KG Maximum Torque 3.5 FT-LBS @ 2500 RPM Maximum RPM 3600 RPM Compression Ratio 8.5:1...
NOTICE is used to address practices not related to personal injury. SAVE THESE INSTRUCTIONS CAUTION, without the safety alert symbol, is used to address practices not related to personal injury. For Engine technical questions, please call 1-800-520-0882. Page 3 SKU 68124...
21. Do not cover the engine or equipment during operation. Do not operate near pilot light or open flame. 22. Keep the equipment, engine, and 5. Do not touch engine during use. Let surrounding area clean at all times. engine cool down after use. Page 4 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
3. Do not alter or adjust any part of the equipment INSTRUCTIONS. or its engine that is sealed by the manufacturer or distributor. Only a qualified service technician may adjust parts that may increase or decrease governed engine speed. For Engine technical questions, please call 1-800-520-0882. Page 5 SKU 68124...
Page 6
Engine Controls Fuel Cap Engine Switch Serial Number Location (Write on front cover of manual.) Oil Drain Plug Dipstick Muffler Throttle Starter Handle Choke Air Filter Page 6 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
6. Thread the dipstick back in clockwise. CAUTION! Do not run the engine with too little oil. The engine will be permanently damaged. Page 8 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
Page 9
Note: Moving the Choke Lever too fast can stall the engine. IMPORTANT: Allow the engine to run at no load for five minutes with no load after each start-up so that the engine can stabilize. 6. Adjust the Throttle as needed. For Engine technical questions, please call 1-800-520-0882. Page 9 SKU 68124...
Engine Switch off. 2. Under normal conditions, use the following procedure: a. Slide the Throttle or Speed Control Lever to SLOW (the “turtle”). b. Turn the Engine Switch off. Page 10 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
2. Check/adjust valve clearance 3. Clean fuel tank, strainer and carburetor 4. Clean carbon build-up from combustion chamber Replace fuel line if necessary Service more frequently when used in dusty areas. These items should be serviced by a qualified technician. For Engine technical questions, please call 1-800-520-0882. Page 11 SKU 68124...
Page 12
6. Clean the top of the Dipstick and the area around it. 3. Install the new filter or the cleaned filter. Remove the Dipstick by threading it counterclockwise, Secure the Air Cleaner Cover before use. and wipe it off with a clean lint free rag. Page 12 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
4. Engine valves or tappets 4. Have qualified technician diagnose/ mis-adjusted or stuck. repair ignition system. Follow all safety precautions whenever diagnosing or servicing the equipment or engine. Page 14 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
3. Intake valve stuck or overheated engine. 3. Have qualified technician diagnose and service engine. 4. Incorrect timing. 4. Check engine timing. Follow all safety precautions whenever diagnosing or servicing the equipment or engine. For Engine technical questions, please call 1-800-520-0882. Page 15 SKU 68124...
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 Camarillo, CA 93011 • (800) 520-0882 Page 16 For Engine technical questions, please call 1-800-520-0882. SKU 68124...
Page 17
Exhaust pipe stud. Muffler. iii) Catalytic converter (if so equipped). Miscellaneous Items Used in Above Systems Vacuum, temperature and time sensitive valves and switches. Hoses, belts, connectors, and assemblies. For Engine technical questions, please call 1-800-520-0882. Page 17 SKU 68124...
Page 19
Parts List and Diagram REV 11h For Engine technical questions, please call 1-800-520-0882. Page 19 SKU 68124...
Page 20
Mounting Hole Diagram Note: Not to scale. 1.44 in. / 36.5mm 4.02 in. / 102mm Power Take-Off Diagram Note: Not to scale. 2x5/16-24UNF 2.37 in. / 60.1mm 1.79 in. / 45.5mm Ø3.625 in. / 92.1mm 0.1875 in. / 4.76mm Ø0.625 in. / 16mm 5/16-24UNF ≥0.98 in.
Need help?
Do you have a question about the 68124 and is the answer not in the manual?
Questions and answers