Table of Contents
Advertisement
3.4 S
M
URROUND
The Surround Monitor unit communicates with the surface using a shared data bus. Each
unit on the data bus must have a unique ID number. The ID number can be in the range of 1 to
16. The position of the unit on the bus does not relate to the ID number.
The Surround Monitor Unit must be set for ID 2.
The first unit on the data bus connects to the PC using a 9 way D to 9 way D type cable.
Each additional unit is connected to the bus using the 9 way D type data link cables.
It is recommended that the Remote Mic Amp be connected at the end of the data bus. The
ID set up for this unit is entered using the menus on the front control panel. The control cable
for the RCMA is a 9 way D to male XLR. This connects from the Data Out connector on the
Monitor unit to the Master Control Input on the RCMA.
R
ONITOR AND
EMOTE
M
A
S
IC
MP
ETUP
22
.
Advertisement
Table of Contents
