Alpine KTX-ALT48 Installation Manual

Perfect fit for 2007-2012 nissan altima

Table of Contents

Download this manual

Perfect Fit For 2007-2012 Nissan Altima Installation Manual

KTX-ALT48

Nissan Trim Panel x 1

Power Harness x 1

Radio Replacement

(Panel 7395)

Interface Module x 1

Left Bracket x 1

Right Bracket x 1

(Panel 7397)

(Panel 7396)

This KTX-ALT48 Perfect Fit installation kit is for Select 2007-2012 Nissan Altima vehicles. In-

cluded are all the parts needed to install your Alpine INE-Z928HD Audio Video Navigation system

in Select 2007-2012 Nissan Altima vehicles. KTX-ALT48 Perfect Fit installation kit also includes

an interface module that allows steering wheel remote control of the Alpine system. Refer to the

individual instruction sections of this manual to remove your vehicle's factory radio and assemble

the kit.

Caution! Disconnect your vehicle's negative battery terminal before the installation to

help prevent electrical damage. We recommend the use of a digital multimeter to check

vehicle wiring. Do not use a test light! A test light or grounded wire probe can cause

damage to the vehicle's computer and/or diagnostic systems. Avoid all factory airbag

wiring. Airbags can accidentally deploy causing serious injury or even death.

Notes:

instructions.

Table of Contents

Do you have a question about the KTX-ALT48 and is the answer not in the manual?

Page 1 Select 2007-2012 Nissan Altima vehicles. KTX-ALT48 Perfect Fit installation kit also includes an interface module that allows steering wheel remote control of the Alpine system. Refer to the individual instruction sections of this manual to remove your vehicle’s factory radio and assemble the kit.
Page 2 Factory Stereo Removal 1. Use a Panel Removal tool to remove the vent panel above the stereo. 2. Use a PRT to remove the panel below the radio 3. Remove 4 Phillips screws securing the radio to the dash. Save these screws. They will be used to install the new kit panel.
Page 3 Mounting The Stereo Continued 2. The kit is designed to work with the digital or analog HVAC controls. Attach the appropriate panel to the front depending on the type of vehicle. 3. Plug in the supplied radio harnesses and steering wheel controls. Run Bluetooth mic & brake wires.
Page 4 Perfect Fit Kit. ALPINE ELECTRONICS OF AMERICA, INC., Do not send products to this address. Call the toll free number or visit the website to locate a service center.