Safety And Instruction Decals; Installation; Mounting The Charger (Model 51596 Only); Mounting The Charger (Model 51597 Only) - Toro 51595 Operator's Manual

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.

Installation

Mounting the Charger (Model
51596 Only)
The charger should be mounted indoors (such as a garage
or other dry place), near a power outlet, and out of reach
of children. You will need to supply three screws with
heads approximately 1/4 inch (6.3 mm) across and, if
mounting the charger on wall board, three wall anchors
for the screws
1. Lay the provided template (page 15) against the wall
and mark the three hole locations as shown in
Figure 1.
Figure 1
2. Drill pilot holes as follows:
If installing the charger on wall board, plaster, or
cement, drill three holes for the wall anchors (as
indicated by the wall anchor manufacturer) at the
marked locations.
If installing the charger on wood, drill three holes,
slightly smaller than the diameter of the screw
threads, at the marked locations.
3. Install the screws as follows:
If installing the charger on wall board, plaster, or
cement, insert the three wall anchors into the holes
then thread the screws into the wall anchors until
they are 1/8 inch (5 mm) from the edge of the wall
anchor (Fig. 2).
ON BLADE
m–4110
5
1
2
Figure 2
1. Wall Anchors
2. Screws
If installing the charger on wood, drive the screws
into the three holes until they are 1/8 inch (5mm)
from the wall.
A. Place the keyhole slots in the back of the charger
over the three screws and push down on the charger
to secure it (Fig. 3).
Figure 3
Mounting the Charger (Model
51597 Only)
The charger should be mounted indoors (such as a garage
or other dry place), near a power outlet, and out of reach
of children. You will need to supply two screws with
heads approximately 1/4 inch (0.6 cm) across and, if
mounting the charger on wall board, two wall anchors for
the screws
ON CHARGER
1
2
3
m–4111
3. 1/8 inch
m–4093