JVC GR-AXM500 Instructions Manual page 69

Original tape (camcorder)
1 3
IN OUT IN OUT
Edited tape (VCR)
RM-V709U
(provided)
SUPPLEMENTAL INFORMATION ON THE REMOTE CONTROL
Player (JVC VCR)
To
Editing cable
R.A. EDIT
(provided)
Recording deck
To
PAUSE IN
RM-V709U
(provided)
2
IN OUT
STOP
MENU Jog Dial
VCR REC STBY
ON/OFF
Using the V709U, it is also possible to perform deck-to-deck Random
AV OUT
Assemble Editing. The playback deck must be an R.A. Edit-capable JVC
VCR. The recording deck can be...
a VCR other than JVC, or
a JVC VCR which has neither a Remote PAUSE nor an R.A. EDIT
connector
How to use:
— Connect the playback deck and RM-V709U as shown on the left.
AV IN
— Set the RM-V709U to correspond to the brand of the recording
deck. (
— For Random Assemble Editing procedure, please refer to the
instruction manual of the JVC VCR you are using as the
playback deck.
Notes:
RM-V709U cannot be used to control the playback deck.
RM-V709U is capable of controlling basic operations of the recording
deck. While pressing VCR CTL, press PLAY, STOP, PAUSE, FF or REW
for these functions. (Not possible with some brands and models).
Other buttons cannot be used.
To put the recording deck in the Record-Pause mode, use the controls
on the recording deck itself.
AUTOMATIC EDITING TO VCR
ENGAGE VCR'S RECORD-PAUSE
MODE
1
Point the remote control towards the VCR's infrared
sensor and press VCR REC STBY, or manually
engage the VCR's Record-Pause mode.
BEGIN AUTOMATIC EDITING
2
Press the MENU Jog Dial on the camcorder, and the
previously selected scenes are copied to the VCR in
the specified order.
While editing, the R.A. Edit counter of the scene
which is beging copied is shown with a blinking
highlight.
END AUTOMATIC EDITING
3
When all selected scenes have been copied, the
camcorder and VCR enter the still or pause mode.
Press STOP on both units. To make the R.A. Edit
counter display disappear, press ON/OFF.
•When finished editing, be sure to disconnect the
editing cable and the audio/video cable.
NOTES:
If you performed step 1
CONNECTIONS"), keep the remote control pointed at
the VCR during editing.
The on-screen display only appears while the
camcorder searches for each scene.
There may be noise at in- or out-points on the edited
tape with certain VCRs.
pg. 66)
EN
on page 67 ("MAKE
C
69