Playback; Record-Standby; Still Playback - JVC GR-AXM240 Instructions Manual

RECORDING
Set REC MODE, S-VHS (S-VHS ET)**, TAPE
LENGTH and DATE/TIME in SYSTEM MENU.
( pg. 18 – 21, "MENU SETTINGS")
1
Remove the lens cap. Set the Power Switch
to " " or " ".
Shooting while using the viewfinder: Make sure
the LCD monitor* is closed and locked.
Shooting while using the LCD monitor*: Make
sure the LCD monitor* is fully open.
The camcorder enters the Record-Standby mode
)
and "PAUSE" is displayed.
• If you tilt the LCD monitor* upward to 180
degrees, the viewfinder switches back on and the
monitored image can be viewed both on the LCD
monitor* and in the viewfinder, so the person you
shoot can view himself/herself.
2
Press the Recording Start/Stop Button
appears while recording is in progress.
• To stop recording, press the Recording Start/Stop
!
Button . The camcorder re-enters the Record-
Standby mode.
To Adjust The Brightness Of The LCD Monitor*,
rotate the BRIGHT Wheel
#
indiator on the display moves and the
appropriate brightness is reached.
* Applicable models only.
** GR-SXM740/SXM540/SXM340/SX970 only.
• Tapes recorded on S-VHS or S-VHS ET
( pg. 18, 20) cannot be played back correctly
on a normal VHS VCR.
To playback on a regular VHS VCR, use a VHS
tape and select S-VHS ET (OFF) in SYSTEM
MENU ( pg. 18, 20).
!
.
1
until the bright level

PLAYBACK

1
Load a tape (
Cassette").
2
Set the Power Switch
playback, press 4/6
@
To stop playback temporarily (Still Playback), press
^ s
or . To stop playback, press 5
4/6
%
to rewind, or 3
2
High-speed picture search (Shuttle Search) is
possible by pressing 2
playback (holding 2
playback continues search until released). To
resume normal playback, press 4/6
For VIDEO RECORDING/VIDEO PLAYBACK
• The camcorder shuts off automatically after about
5 minutes in the Record-Standby or Stop mode.
To turn on again, set the Power Switch
7 "OFF", then to "
• When the Power Switch
" " and the LCD monitor* is opened at an
angle of 60 degrees or more, the LCD monitor*
switches on and the viewfinder switches off
automatically to save power.
• The playback picture can be viewed in the
viewfinder (with the LCD monitor* shut), on the
LCD monitor* or on a connected TV (
"Connections To A TV/VCR").
• To remove the indications,
OSD OUTPUT in SYSTEM MENU.
• To control the speaker* volume, slide VOL.
towards "+" to turn up, or towards "–" to turn
down. While shooting, sound is not heard from
the speaker*.
• If TBC ( pg. 14) is engaged during Still
Playback, noise bars will not appear
(GR-SXM740/SXM540/SXM340 only).
* Applicable models only.
11
pg. 8, "Loading/Unloading A
@
to " ". To start
^ T
or .
&
to fast-forward the tape.
% &
or 3 during
% &
or 3 down during
^
or
", " " or " ".
@
is set to "
pg. 21, DISPLAY or
$
. Press
T
.
@
to
", " " or
pg. 15,
3