Esp Safety Switching - Audi 243 Service Manual

ESP safety switching

For technical reasons it is not possible to
change levels/self-level during cornering. If
cornering is recognised, no control functions
are performed and control functions already
running are interrupted. The target level
remains stored and is reset when straight-
ahead driving is recognised.
In the Audi allroad quattro it is possible to
influence certain ESP functions using the ESP
button.
You can find further information about this in
SSP 241, from page 67 onwards.
If ESP influences have been activated (via ESP
button, ESP warning lamp illuminated), the
transverse dynamics control (anti skid
function) is passive (not during braking).
No self-levelling while
cornering
HL2
HL1
NL
LL
0 35
If, for example, the vehicle is at high level 2
with active ESP influences and the driver
accelerates sharply on a very winding route,
speeds of > 35 km can be achieved in high
level 2. In order to guarantee maximum safety
in such driving conditions, ESP influences are
automatically deactivated at a speed of
> 70 km/h, despite the high centre of gravity
of the vehicle (ESP-safety switching).
Normal ESP functions are available again and
the ESP warning lamp extinguishes.
This ESP safety switching takes place as of
70 km/h at high level 2 and as of 120 km/h at
high level 1.
There is no ESP safety switching at normal
level or low level.
No self-levelling while
cornering
70 80 120
Cornering is detected by the J197 self-
levelling control unit by evaluation of
the signals from the four level sensors.
ESP switching at high level 2
ESP switching at high level 1
Speed km/h
243_027
13