Advertisement
ASSEMBLY OF THE FAN
1. Attach the column to the stand with 4 screws
2. Slide the stand cover down the column to rest on the stand.
3. Attach the front guard ornament to the front guard.
4. Remove the blade cap and guard mounting nut from the motor shaft. Attach the rear
guard to the motor shaft and tighten the rear guard mounting nut.
5. Install the fan blade onto the motor shaft, ensuring the retaining pin snaps into the
groove on the blade. Turn the blade cap counter clockwise to fix the fan blade into
position.
6. Mount the front guard and fix both guards together with the guard hoop.
OPERATING INSTRUCTIONS
This unit is supplied with a remote control which is active up to five meters. The unit can
be operated using the remote control or by using the buttons on the unit. For each
selection, the relevant indicator lights will light up on the control panel on the unit.
Speed: Press the On/Speed button to start the unit. Press this button once for low
speed, twice for medium speed and three times for high speed.
Wind type: Three wind speed settings are available. The first setting is Normal,
where the unit will blow at a constant speed as per your speed selection. The second
setting is Natural, where the unit will blow at higher and lower speeds alternatively,
again as per your speed selection. The third setting is Sleeping, where the unit will
blow at a high speed for 30 minutes, then at medium speed for 30 minutes and then
at low speed until the preset time is over.
Timer: The unit can be programmed to run for a preset length of time, ranging from
0.5 hours to 7.5 hours. Press the Timer button until the desired time limit is reached.
Oscillation: To make the fan head swing from side to side, press the Oscillation
button once, and again to make the fan head stay in one place.
Off button: This button will turn the unit off.
The fan head can also be tilted in a vertical direction. For height adjustment, loosen
the pipe screw, move the extension pipe up or down to reach the desired height and
fasten the pipe screw until tight.
4
Advertisement
