Insert Editing - JVC GR-AX220 Instructions Manual

40
USING REMOTE CONTROL UNIT
COUNTER R/M
POWER
M-1:23:45
Viewfinder
RM-V700U
OR
(optional)
Tape Counter

Insert editing

indicator
START/STOP
REW
PLAY
PAUSE
REW
INSERT
RM-V705U (provided
with GR-AX720 only)
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V705U or RM-V700U remote control unit to
perform this procedure.
SELECT MODE
1
Set the Power switch to "PLAY".
FIND EDIT-OUT POINT
2
Play back the tape, locate the point and press
PAUSE on the camcorder or the remote control.
RESET COUNTER
3
Press and hold COUNTER R/M for more than
2 seconds to reset the tape counter, then press for
less than 1 second and make sure "M" appears in
the viewfinder.
FIND EDIT-IN POINT
4
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE at exactly at the
point where the new scene should start.
ENGAGE INSERT EDITING MODE
5
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert
mode is engaged, and the scene the camcorder is
aimed at appears on the screen.
BEGIN INSERT EDITING
6
Press RECORDING START/STOP. When the counter
reaches "0:00:00", editing stops automatically and
the camcorder enters the Insert-Pause mode.
END INSERT EDITING
7
Press STOP.
NOTES:
After step 5, Retake (
The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.
(GR-AX720 only) (cont.)
pg. 16) can be performed.