Advertisement
TDK.122.02_DVD Hardware V1
10/16/02 12:02 PM
Primary
IDE port
Secondary
IDE port
For best results, set Indi DVD's jumper to
NOTE:
Master. If applicable, enable your system's DMA
setting to achieve maximum writing speed.
Primary
IDE port
Secondary
IDE port
Primary
IDE port
Secondary
IDE port
4
Indi DVD ReWRITER : Hardware Guide
Page 4
INSTALLING Indi DVD
Connected as CSEL
Connected as CSEL
HARD DRIVE
HARD DRIVE
Connected as CSEL
Connected as CSEL
Set Indi DVD's
INDI DVD
jumper to:
CD-ROM
CS
S
M
Connected as Master
Connected as Slave
HARD DRIVE
HARD DRIVE
Connected as Master
Connected as Slave
Set Indi DVD's
INDI DVD
CD-ROM
jumper to:
CS S
M
Set Indi DVD's
jumper to:
HARD DRIVE
HARD DRIVE
CS S
M
If your sytstem is
the Master/Slave
type
Set Indi DVD's
INDI DVD
jumper to:
CS S
M
If your sytstem is
the Cable Select
(CSEL) type
The jumper's position determines whether Indi DVD is set to Master, Slave or Cable Select (CSEL). In
the example below, Indi DVD's jumper is set to CSEL.
Cable Select
Master
Slave
For Factory Use
Only
If Applicable
Indi DVD's rear-panel jumpers
To change Indi DVD's jumper setting:
1. Remove the jumper with your fingers or needle nose pliers.
2. Place the jumper in the new setting. For example, to make Indi DVD a Slave, move the jumper to
the center set of pins, leaving the other pins uncovered. To change the drive to Cable Select, move
the jumper to the left set of pins. Make sure to insert the jumper vertically rather than horizontally.
See below.
DO NOT install jumpers this way
(horizontally)
Jumper
Install jumpers this way
(vertically)
To change your old drive's jumper setting (if required):
1. Disconnect the power supply from the drive.
2. Disconnect the IDE cable from the drive.
3. Disconnect the audio cable from the drive.
4. Remove the drive from your PC.
5. Using your fingernails or needle-nose pliers, change the jumper to the new setting.
6. Place the drive back into the computer.
7. Reconnect the audio cable.
8. Reconnect the IDE cable.
9. Reconnect the power supply.
5
SECTION 1 : Drive Installation
Advertisement
