Advertisement

Air Compressor
Manual
For questions concerning this air compressor,
please call: 1-877-861-2722.
Rev. 0611
Printed In USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Air Compressor and is the answer not in the manual?

Questions and answers

Phillip Abner
March 10, 2025

How much oil in a bellaire 216 v 5 hp compressor?

1 comments:
Mr. Anderson
May 14, 2025

The oil capacity for a BelAire 216V 5 HP air compressor is not provided in the given information.

This answer is automatically generated

Summary of Contents for BelAire Air Compressor

  • Page 1 Air Compressor Manual For questions concerning this air compressor, please call: 1-877-861-2722. Rev. 0611 Printed In USA...
  • Page 3: Table Of Contents

    TABLE OF CONTENTS PAGE Safety Guidelines - Definitions Before Using the Air Compressor When Installing or Moving the Compressor Before Each Use Follow Safety Precautions for Electrical Connection Plan Ahead to Protect Your Eyes, Hands, Face & Ears When Operating...
  • Page 4: Safety Guidelines - Definitions

    Improper operation or maintenance of this product could result in serious injury and property damage. Read and understand all warnings and operation instructions before using this compressor. Before using the air compressor Things you should know Inspect your work area Air compressors are utilized in a variety of air 1.
  • Page 5: When Installing Or Moving The Compressor

    When installing or moving the compressor WARNING 6. A minimum clearance of 18 inches between the compressor and a wall is required This compressor is extremely top heavy. The because objects could obstruct airflow. compressor must be bolted to the floor with vibration pads before operating to prevent 7.
  • Page 6: When Operating

    Follow the safety precautions for electrical connections 1. Follow all local electrical and safety codes, 3. Protect wires from contact with sharp objects. as well as the National Electric Code (NEC) and the Occupational Safety and Health Act (OSHA). CAUTION 2.
  • Page 7: Spraying Precautions

    WARNING 3. Clean electrical equipment with an approved Disconnect power and depressurize system cleaning agent, such as a dry, non-flam- before servicing air compressor. Slightly open mable cleaning solvent. drain cock after shutting off compressor. Daily Monthly (Make sure the main power is off.) Check the belts...
  • Page 8: Typical Compressor Installation

    TYPICAL COMPRESSOR INSTALLATION WIRING To Air System Flex Regulator Hose Dryer Vibration Pads GLOSSARY OF TERMS Air Filter Pressure Switch Porous element contained within a metal or Device which automatically controls the on/off plastic housing attached to the compressor cycling of the compressor. It stops the cylinder head which removes impurity from the compressor when the cut-off pressure in intake air of the compressor.
  • Page 9: Starting The Compressor (Electric Compressors)

    WIRING WIRING For Models Without Magnetic Starter WARNING Incoming power should ALL ELECTRICAL WIRING SHOULD BE DONE be connected to the BY A QUALIFIED ELECTRICIAN posts marked (line) General Information Adequate wiring and motor protection Do Not Make should be provided for all stationary Connections On compressors.
  • Page 10 Starting Your Compressor (Gas Drive Models) Electric start models: (See Engine Manual for More Detailed Instructions) Make Sure There is Gas in the Gas Tank Honda: Turn the gas lever to the “on” position. Turn the choke lever to the left. Turn key to the “on”...
  • Page 11 QP Compressors You have purchased a state of the art BelAire QP compressor. The QP comes equipped with sound attenuating enclosure. For maintenance, the canopy and side foam pieces will need to be removed. To remove the canopy, simply remove the 6 fasteners and lift the canopy straight up and off.
  • Page 12: Troubleshooting Guide

    TROUBLESHOOTING GUIDE Low discharge pressure 1. Compressor too small for 1. Reduce air demand or use a compressor application with more air capacity. 2. Listen for air leaks. Apply a soap solution 2. Air leaks to all fittings and connections. Bubbles will form at points of leakage.
  • Page 13 TROUBLESHOOTING GUIDE (Continued) Pressure switch un- 1. Malfunctioning check valve 1. Replace check valve if unloader bleeds loader constantly constantly. Do not remove check valve leaking air DANGER with air pressure in tank Pressure switch not 1. Malfunctioning pressure 1. Replace pressure switch if it does not release unloading switch air pressure briefly when unit shuts off.
  • Page 14 Notes...
  • Page 15 Notes...
  • Page 16: Warranty Statement

    IMPAIRMENT OF OTHER GOODS, LOSS BY REASON OF SHUTDOWN OR NON-OPERATION, COST OF PURCHASE OF REPLACEMENT POWER, OR CLAIMS OF PURCHASER OR CUSTOMERS OF PURCHASER FOR SERVICE INTERRUPTION, WHETHER OR NOT SUCH LOSS OR DAMAGE IS BASED ON CONTRACT, WARRANTY, NEGLIGENCE, INDEMNITY, STRICT LIABILITY OR OTHERWISE. BelAire Compressors 1800 Overview Drive Rock Hill, SC 29730...

Table of Contents

Save PDF