JVC HR-S8700EU Instructions Manual page 66

66
EN
AUTO SP LP TIMER
8 ]
ON
OFF
DIGITAL 3R
8
ON
OFF
POWER SAVE
8
ON
OFF
VIDEO STABILIZER
8
ON
OFF
When this function is set to "ON", the recorder automatically switches to LP
mode to allow complete recording if there is not enough tape to record the
entire programme while timer-recording in SP mode.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set this function to "ON", before the timer-recording starts.
NOTES:
If you have programmed the recorder to timer-record 2 or more programmes, the
second programme and those thereafter may not fit on the tape if you set "AUTO
SP LP TIMER" to "ON". In this case, make sure the mode is not engaged, then set
]
the tape speed manually during timer programming.
In order to ensure that the recording fits on the tape, this feature may leave a slight
non-recorded section at the end of the tape.
There may be some noise and sound disturbance at the point on the tape where the
recorder switches from SP to LP mode.
The Auto SP LP Timer feature is not available during ITR (Instant Timer Recording),
]
and the feature will not work properly with any tapes longer than E-180, or with
some tapes of shorter lengths.
If you perform timer recording with both VPS/PDC and the Auto SP
activated, and the programme goes beyond its originally scheduled length, there
may be times when the programme cannot be recorded in its entirety.
When this function is set to "ON", the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.
NOTES:
Normally it is recommended to keep "DIGITAL 3R" set to "ON".
Depending on the type of tape being used, picture quality may be better with
"DIGITAL 3R" set to "OFF".
If you use the recorder as the source player for editing, be sure to set "DIGITAL 3R"
to "OFF" before starting.
When this function is set to "ON", you can reduce the power consumption
while the recorder is turned off.
NOTES:
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
... the picture may be distorted momentarily when you turn on/off the recorder.
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder's power is turned off after timer-recording or Instant Timer
Recording.
... the Automatic Satellite Programme Recording mode is engaged (
... "L-2 SELECT" is set to "DECODER" or "SAT" (
When this function is set to "ON", you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder.
NOTES:
When you finish viewing a tape, be sure to set this function to "OFF".
Regardless of the setting, this function has no effect during recording and during
special effects playback.
The on-screen display may jitter vertically when this function is set to "ON".
To watch recordings with close-caption, set this function to "OFF".
Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you activate
Digital TBC/NR when "VIDEO STABILIZER" is set to "ON", Video Stabilizer will be
automatically turned "OFF".
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
Approximately 60 minutes
LP mode
pg. 76) does not work.
pg. 51).
LP Timer
]
pg. 36).