State of Your safe use of this Mantis product is one of our prime design objectives. Many safety features are built in, but we also rely on your California to cause cancer, birth defects and other good sense and care to achieve accident-free operation.
For 1. Do not put hands or feet near or under rotating parts. service please contact Mantis. A Mantis representative Keep clear of the discharge opening at all times. can direct you to an AUTHORIZED SERVICE CENTER for...
Failure to comply could result in accidental you careless. Remember that a careless fraction of starting and possible serious personal injury. a second is sufficient to inflict serious injury. Contact us at www.mantis.com • (800) 366-6268 8 Amp 12” Electric Snow Shovel Operator’s manual...
Total Length of Cord in Feet (meters) more Than Not more Than 25' (7.6 m) 50' (15 m) 100' (30.4 m) 150' (45.7 m) Not Recommended Contact us at www.mantis.com • (800) 366-6268 8 Amp 12” Electric Snow Shovel Operator’s Manual...
Risk of damage to the electrical system and risk suitable brush. of electric shocks. • Check that there are no damaged or loose parts. Repair/ replace parts if necessary. Contact us at www.mantis.com • (800) 366-6268 8 Amp 12” Electric Snow Shovel Operator’s manual...
Impeller Pulley In order to reduce the risk of electric shock, replace the cover before connecting the snow shovel to a power source. FIGURE 8 Contact us at www.mantis.com • (800) 366-6268 8 Amp 12” Electric Snow Shovel Operator’s Manual...
Page 8
• Re-install the impellor shaft hand side of the impellor. side. remaining screws and the nut nut and washer on the right and washer. hand side, and tighten. Contact us at www.mantis.com • (800) 366-6268 8 Amp 12” Electric Snow Shovel Operator’s manual...
(see the section entitled Starting the snow shovel). MANTIS will repair or replace, at its discretion, any part or parts of the product found to be defective in material or workmanship during the warranty period. Warranty repairs and 2. The motor is on, but the rotor •...
Need help?
Do you have a question about the 8112 and is the answer not in the manual?
Questions and answers