LG DLGX3371 Series Owner's Manual page 30

30
INSTALLATION INSTRUCTIONS
Installation Test (Duct Check) (cont.)
Error Code
or
or or
If the FLOW SENSE TM LED is turned on, check the
exhaust system for restrictions and damage. Repair or
replace the exhaust system as needed.
NOTE
When the dryer is first installed, this test should be
performed to alert you to any existing problems with
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than does the installation test, the num-
ber of bars displayed during the two tests may not be
the same.
Do not interrupt the test cycle, as this could result in
the wrong results.
Even if no bars are displayed during the test cycle,
some restrictions may still be present in the exhaust
manual for complete exhaust system and venting
requirements.
Your dryer features Flow Sense™, an innovative sens-
ing system that automatically detects blockages and
clean of lint buildup and free of restrictions allows
clothes to dry faster and reduces energy use.
Possible Causes
connected correctly, or house power
supply is incorrect.
tripped, or power outage has occurred.
Turn off the dryer and call for service.
Turn off the dryer and call for service.
power cord to the terminal block. Refer to the
manual for complete instructions.
increase the fuse capacity. If the problem is a
circuit overload, have it corrected by a quali-
fied electrician.
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Check for blockages and lint buildup.
Make sure the ductwork is not crushed or restricted.
Solutions
section of this
Too many elbows or
exhaust too long
Lint buildup
or blockage
Crushed or
damaged
exhaust