Heating - KODA Citigo Owner's Manual

Škoda citigo
Table of Contents

Advertisement

Note
Do not cover the air outlet vents with objects of any kind.
Using the air conditioning system economically
First read and observe the introductory information and safety warn-
ings
on page 55.
The compressor on the air conditioning system uses power from the engine when
in cooling mode which will effect the fuel consumption.
It recommended to open the windows or the doors of a vehicle for which the inte-
rior has been strongly heated through the effect of direct sunlight in order to al-
low the heated air to escape.
The cooling system should not be switched on while travelling when the window
is open.
If the desired interior temperature can also be achieved without activating the
cooling system, fresh air mode should be selected.
For the sake of the environment
Pollutant emissions are also reduced when fuel is saved
Operational problems
First read and observe the introductory information and safety warn-
ings
on page 55.
If the cooling system does not operate at outside temperatures higher than +5 °C,
there is a problem in the system. The reasons for this may be.
One of the fuses has blown. Check the fuse and replace if necessa-
ry
» page
148.
The cooling system has switched off automatically for a short time because the
coolant temperature of the engine is too hot
If you are not able to resolve the operational problem yourself, or if the cooler
output has reduced, switch off the cooling system and seek assistance from a
specialist garage.
56
Using the system
» page
71.
» page
13.

Heating

Introduction
This chapter contains information on the following subjects:
Control elements
Setting heating
Control elements
Fig. 64 Heating: Control elements
First read and observe the introductory information given on page 56.
Setting temperature
Turn the control dial
» Fig. 64
A
Turn the control dial
to the left to decrease the temperature.
A
Controlling blower
Turn the blower switch
» Fig. 64
B
blower on.
Turn the blower switch
into position 0 to switch the blower off.
B
Regulating the air distribution
The direction of the inlet air flow is controlled with air distribution regulator
» Fig. 64 » page
55, Air outlet vents.
C
to the right to increase the temperature.
into one of the positions 1-4 to switch the
56
57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents