Cleaning Your Burr Mill; Troubleshooting Your Oster ™ Burr Mill Coffee Grinder; Cleaning Instructions - Oster Burr Mill BVSTBMH Series User Manual

11. Clean after every third use for best performance.
12. After using, open the grinder to the coarsest setting and run empty to clear the
grinding path.
NOTE: For optimum freshness of your coffee beans, do NOT store in the bean hopper
for extended periods of time.

CLEANING INSTRUCTIONS

Remember to always clean your Burr Mill before using it for the first time. Then, to
ensure optimal mill function and durability, clean it regularly following these simple
steps:
1. Always unplug your Burr Mill after use and before cleaning.
2. Wash the bean hopper and coffee chamber parts with warm soapy water. (Never
use abrasive cleansers, steel wool pads or other abrasive materials. UNIT IS NOT
DISHWASHER SAFE)
CAUTION! Never immerse the Burr Mill itself in water, in any other liquid or place
in the dishwasher.
3. Dry all pieces thoroughly.
4. Install the Bean Hopper onto the unit and turn clockwise (several rotations-will hear
clicking as unit gets tighter) until it stops with the grind size indicator on Fine.
5. Place chamber lid back on grinder chamber and then install into unit, tightly locking
into place.
NOTE: If all Bean Hopper and Grinding Chamber parts are not tightly in place correctly,
the safety switches within the machine will not allow the grinder to work. You
MUST have all parts in place to safely use the Burr Mill.
TROUBLESHOOTING YOUR Oster
Your Oster Burr Mill coffee grinder has been carefully designed to give you many years of
™
trouble-free service. In the unlikely event that your new Burr Mill does not operate satisfactorily,
please review the following potential problems and try the steps recommended BEFORE you call
an Authorized Sunbeam Service Center.
PROBLEM
THE UNIT DOES
NOT GRIND
10
COFFEE GRINDER
POSSIBLE CAUSE
• Hopper is not securely intact
• Hopper lid is not on tight
• Ground coffee chamber is not in
position
• Start button has not been pressed
• Unit is unplugged
• There's a power outage
• Motor has overheated, thermal fuse
is open
• Hopper Chute Clogged (or Blocked)
BURR MILL
™
SOLUTION
• TURN HOPPER CLOCKWISE UNTIL STOPS, THEN
MOVE INDICATOR COUNTERCLOCKWISE, BACK
TILL YOU HAVE INDICATOR LINED UP WITH
DESIRED GRIND SETTING
• SECURE HOPPER LID
• PLACE CHAMBER IN PROPER POSITION
• PRESS AND HOLD BRIEFLY START/STOP BUTTON
• PLUG UNIT IN
• WAIT FOR POWER TO BE RESTORED
• UNPLUG UNIT FOR AT LEAST AN HOUR THEN
PLUG BACK IN AND USE AS NEEDED
• REMOVE HOPPER & EMPTY TO CLEAR
BLOCKAGE