Toro Super Recycler 20382 Operator's Manual page 6

2
Installing the Starter Rope
No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 5).
1. Starter rope
Note: To make the rope easier to install, squeeze the
control bar on the handle.
3
Filling the Engine with Oil
No Parts Required
Procedure
1. Remove the dipstick (Figure 6).
2. Slowly pour oil into the oil fill tube, periodically
checking the level with the dipstick, until the dipstick
indicates that the engine is full as illustrated in
Figure 5
2. Rope guide
G017482
Figure 6
Figure 6. Wait 3 minutes after adding oil to check
the oil level with the dipstick. Do not overfill. (Max.
fill: 0.58 quart or 18.6 oz. (0.55 l), type: SAE 30
detergent oil with an API service classification of
SH, SJ, SL, or higher.)
Note: If you overfill the engine, pour some oil out
of it as directed in Changing the Engine Oil.
3. Install the dipstick securely.
Important: Change the engine oil after the first
5 operating hours ; change it yearly thereafter.
Refer to Changing the Engine Oil.
Product Overview
5
4
3
2
1
1. Cutting height lever (4)
2. Spark plug
3. Air filter
4. Oil fill/Dipstick
5. Fuel tank cap
6. Discharge deflector
1. Grass bag
2. Side discharge chute
6
8
9
7
6
10
11
G017481
Figure 7
7. Recoil start handle
8. Blade control bar
9. Upper handle
10. Grass bag
11. Washout port
Figure 8
3. Rear discharge plug
(installed)