CITROEN C6 Owner's Handbook Manual page 42

Citroën c6
Hide thumbs Also See for C6:
Table of Contents

Advertisement

II
38
OPERATING THE ALARM
First make sure all the doors are closed.
The alarm is armed by pressing button B on the remote
control.
With the alarm armed, the protections are active after 5
seconds (perimeter) and 45 seconds (volumetric).
When the alarm is armed (on standby), any intrusion
will trigger the siren for 30 seconds, accompanied by
the direction indicators lighting up.
The alarm then goes back on standby, but the trigger-
ing remains memorised and is signalled by the rapid
flashing of the warning lamp on control 1 after you have
deactivated the alarm with a press on the unlocking
button A. The flashing stops when you switch on the
ignition.
The siren is also triggered if there is a cutting of the
electrical supply. To stop it, restore the electrical supply
then press on the unlocking button A.
Note :
If you want to lock your vehicle without arming the
alarm, just lock with the key only.
If you lock your vehicle and a door, or the boot, is still
open, the central locking does not operate but the
alarm will arm itself after approx. 45 seconds.
Note : The siren is automatically deactivated (for exam-
ple for disconnecting the battery) as soon as the vehicle
is unlocked using the remote control.
Anglais_indexe.indd Sec1:38
Anglais_indexe.indd Sec1:38
A N T I - I N T R U S I O N A L A R M
Deactivating the volumetric detection
You can operate the alarm with perimeter protection
only, by deactivating the volumetric protection (if for
example you wish to leave an animal in the vehicle).
For this, switch off the ignition then immediately press
button 1 for at least one second.
The warning lamp on button 1 should come perma-
nently on. It will start to flash when the alarm is armed.
Arm the alarm by locking your vehicle with the remote
control.
Automatic activation (according to destina-
tion)
The alarm is armed automatically, 2 minutes after the
last door, or the boot, has been closed.
In order to prevent the alarm from triggering when you
open one of the doors or the boot, it is essential to press
the unlocking button A again on the remote control.
A
B
06/10/2005 14:10:57
06/10/2005 14:10:57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents