Advertisement
Parts:
1-Driver Side Enclosure
1-Passenger Side Enclosure
1-Driver No Velcro Piece (zipper)
1-Passenger No Velcro Piece (zipper)
1-Driver Side Track
1-Passenger Side Track
Installation Instructions:
1. Begin by installing the driver side track in the location as shown in figure 3-1. When posi-
tioned correctly on the roof the notch on the end of the track should wrap around the front
windshield frame. Once the track is in the correct position, secure the track to the roof with
the supplied hex head self drilling screws in the 5 locations as shown in figure 3-1.
2. Slide the driver side enclosure on to the newly installed track.
3. Position the front windshield to the upward closed position.
4. Attach the driver side no Velcro piece (zipper) to the front of the driver side enclosure.
5. The welt that slides into the track on the no Velcro piece will need to be notched to fit
around the windshield clamp. With the no Velcro piece attached to the side of the curtain
pull it up to the side of the windshield frame to mark the notch location on the no Velcro
piece. Once you have made your marks remove the no Velcro piece from the side of the
curtain and cut out the notch in the welt. When finished it should look similar to figure 3-2.
6. The no Velcro driver side track will need to be cut to fit around the windshield clamp as
well. Use the no Velcro piece that you just notched as a guide to mark and cut the no Velcro
driver side track. The notch will need to be exactly the same as the no Velcro piece.
7. Install the driver side no Velcro tracks to the back side of the windshield frame. Apply the
adhesion promoter to the surface area of where the track is to be installed. Immediately after
applying the adhesion promoter remove the plastic backing from the track and adhere the
track to the proper location on the windshield frame.
8. Install three flat head self drilling screws on the inside of the no Velcro track securing it to
the windshield frame
9. Position the front windshield to the downward open position.
10. Slide the no Velcro piece into the newly installed no Velcro track.
11. Position the front windshield to the upward position as shown in figure 3-3.
12. Zip the enclosure side to the no Velcro piece.
13. From the inside of the golf cart install a flat head self drilling screw into the side of each no
Velcro track as shown in figure 3-4.
14. Install snap screw and snap in the bottom of the no Velcro piece as shown in figure 3-5.
Please note that the snap screw is not a self drilling screw and a pilot hole should be made
with an 1/8" drill bit.
15. Install snap screws and snaps in the enclosure side as shown in figure 3-6.
16. Repeat the above steps on the passenger side.
LJ'S TOPS & BOTTOMS, Inc.
"Specializing in Golf Car Enclosures"
Ph: (561)736-7868 Fax: (561)375-9171
Enclosure Sides
2-No Velcro tracks
12-Flat Head Self Drilling Screws
10-Hex Head Self Drilling Screws
12-Snap
12-Snap Screw
6
Hide quick links:
Advertisement
