®
®
For Genesis 1, 2, 3, 4, 5 and Perma-Mount Gas Barbecues
Note - Figures in these instructions are intended to
represent all Genesis Gas Barbecue models, your
barbecue may differ from these illustrations.
®
®
Your Weber
Genesis
Gas Barbecue, as well as any
outdoor gas appliance, is a target for spiders and other
insects. They can nest in the venturi section of the
burner tubes. This blocks the normal gas flow, and can
cause the gas to flow back out of the air shutter.
Figure 1. This could result in a fire in and around the air
shutters, under the control panel, causing serious
damage to your barbecue. We have developed the
Weber Spider Stopper Guards to significantly
reduce the chance of this happening to your Weber
Genesis Gas Barbecue.
Venturi
Air shutter
Figure 1
The Weber Spider Stopper Guard fits tightly around the
air shutter section of the burner tube and the valve,
thereby preventing spiders and other insects access to
the burner tubes through the air shutter openings.
Figure 2.
Weber Spider
Stopper Guard
Figure 2
Weber
Spider Stopper
®
Installation Instructions
We recommend that you inspect the Weber Spider
Stopper Guards at least once a year. Also inspect and
clean the Spider Stopper Guards if any of the
following symptoms should ever occur.
1. The smell of gas in conjunction with the burner
flames appearing yellow and lazy.
2. Barbecue does not reach temperature.
3. Barbecue heats unevenly.
4. One or more of the burners do not ignite.
DANGER
Failure to correct these symptoms may
result in a fire which can cause serious
bodily injury or death, and cause damage
to property.
WARNING: Make sure gas supply is turned off; i.e.:
LP cylinder valve is closed or natural gas supply
shut-off turned off and hose disconnected from the
Quick Disconnect.
Note - You should inspect the burners for spider webs
and other obstructions before installing your new
Weber Spider Stopper Guards. To inspect the burners,
you must remove the manifold. The following
instructions show you how to both remove the manifold
and install the Weber Spider Stopper Guards.
Step 1
For LP units only, disconnect the gas hose from the LP
tank.
Step 2
Pull off all burner control knobs. Remove control panel.
Step 3
Remove the igniter.
Guards
™
27-39900
Rev. 3/90