Table of Contents
Advertisement
12•8 Body electrical system
11.19 Removing a rear foglamp lens
11.25a Under-bonnet lamp unclipped note
earth screw (arrowed)
Rear foglamp
19 Remove the lens from the foglamp by
undoing its two retaining screws (see
illustration).
20 Extract the bayonet fitting bulb and fit the
new one.
21 Refit and secure the lens.
Number plate lamp
22 Prise the lamp unit out of the rear bumper
and
disconnect
its
wiring
illustration).
23 Unclip the two halves of the lamp unit to
gain access to the bulb (see illustration).
24 Refit in the reverse order to removal.
Interior lamps
25 Bulb renewal is similar for all types of
interior lamp, and for the under-bonnet lamp
(when fitted). Either unclip the lamp cover, or
11.27 Removing an instrument panel bulb
11.22 Prising out the number plate lamp
11.25b Luggage area lamp unclipped
carefully prise the lamp unit from its location
(see illustrations).
26 Extract the old bulb. fit the new one and
refit the lamp or cover.
Instrument illumination and
warning lamps
27 Instrument panel illumination and warning
lamp bulbs can be removed by turning the
combined
clockwise and withdrawing it from the rear of
the panel (see illustration). There is no need
plug
(see
to withdraw the panel completely to do this -
just withdraw it far enough to gain access to
the printed circuit.
Switch illumination bulbs
28 Switches such as the lighting master
switch and the heated rear window/heater
blower control are illuminated by bulbs which
can be renewed after removal of the switch
(see illustration).
11.28 Removing a switch illumination bulb
bulbholder
assembly
anti-
11.23 Number plate lamp bulb holder and
lens separated
11.25c Removing the cover from the main
interior lamp
29 The pilot illumination in switches such as
that controlling the foglamps is integral with
the switch and cannot be renewed separately.
Check control display lamps
30 Carefully prise the check control unit from
its location. The bulb holders are accessible
from below.
31 Refit in the reverse order to removal.
12 Headlamp/direction indicator
lens assembly - removal and
refitting
Removal
1 Remove the direction indicator, headlamp
and sidelamp bulbs (Section 11).
2 Undo the securing screw and withdraw the
direction indicator lens (see illustrations).
12.2a Undoing a direction indicator lens
screw
Hide quick links:
Advertisement
Table of Contents
