Download Print this page

Billi B-6000 Installation Manual

Boiling and chilled filtered water system
Hide thumbs Also See for B-6000:

Advertisement

Quick Links

B–6000
Installation guide
Boiling and Chilled
Filtered Water System
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the B-6000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Billi B-6000

  • Page 1 B–6000 Installation guide Boiling and Chilled Filtered Water System...
  • Page 2: Installation Requirements

    3. Dispenser base & mount on the sink side of the water trap. The B-6000 manufacturer’s instructions. 4. Barb locking bush dispenser incorporates an externally vented 5.
  • Page 3 Installing the Installing dispenser. underbench module. IMPORTANT: Remove burrs and check internal 1. Flush water supply bore is completely smooth. Flush water supply pipework before installing the underbench unit by connecting 450mm 4. Fit dispenser head assembly flexible braided hose to the supply tap and a.
  • Page 4 Correct timing of the moment of reduced flow is dependent —CAUTION on the length of the tube between the B-6000 Steam will discharge from the vent module and the dispenser. The standard outlet located between the hot and timing is set for a tube length of 500mm but cold water outlets.