Table of Contents
Advertisement
www.reelschematic.com
www.reelschematic.com
Mounting the GPSMAP 162 Unit
The GPSMAP 162' s compact, waterproof case is suitable for mounting in exposed locations or at the
nav station. The unit comes with a gimbal bracket that can be used for surface or overhead mounting.
When choosing a location for the display unit, make sure you consider the following conditions:
• There should be at least a 3" (5 cm) clearance behind the case to allow connection of the
antenna (external antenna only), power/data cables.
• The mounting surface should be heavy enough to support the unit and protect it from excessive
vibration and shock.
• For unit' s with the built-in internal bail mount antenna (010-00192-00), it should be mounted
in a location that has the clearest, most unobstructed view of the sky in all directions to
ensure the best reception. Avoid mounting the unit where it will be blocked by the boat' s
superstructure, a radar arch, or mast.
I
The temperature range for the GPSMAP 162 is 5°F to 158°F (-15°C to 70°C). Extended
exposure to temperatures exceeding this range (in storage or operating conditions) may
cause failure of the LCD screen. This type of failure and related consequences are NOT
covered by the manufacturer's limited warranty.
To install the GPSMAP 162 unit:
1. Place the mounting bracket in the desired location.
2. Mark and drill the four mounting holes for the fastener you are using.
3. Fasten the bracket to the surface using the appropriate fastener.
4. Insert the GPSMAP 162 into the mounting bracket. The bracket is designed for a tight fi t to provide
additional support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into the display case.
6. Connect the power/data and antenna cables (external antenna only) to the back of the unit, making
sure the locking rings are fully tightened on both connectors.
Appendix G
Unit Installation
83
Advertisement
Table of Contents
