Advertisement
Table of Contents
- 1 Table of Contents
- 2 Technical Manual for the Installer
- 3 Inserting the Hob
- 4 Fixing the Hob - Advice about Installation
- 5 Ventilation and Airing of the Premises - Connection to the Gas Supply
- 6 Adaptation to Different Types of Gas
- 7 Regulation of the Burners
- 8 Connection to the Electricity Supply
- 9 MAINTENANCE of the APPLIANCE - Replacing Parts
- 10 Use and Maintenance Manual
- 11 Description of Types of Hobs
- 12 Use of the Burners
- 13 Routine Maintenance
- 14 Cleaning of the Appliance
- 15 Figures
- 16 Electrical Diagran
- Download this manual
Advertisement
Table of Contents
Related Manuals for La Germania P6801H9X
Summary of Contents for La Germania P6801H9X
- Page 1 INSTRUCTIONS FOR THE INSTALLATION, MAINTENANCE AND USE OF FIXED HOBS WITH GAS OR MIXED SUPPLY 59X50 cm (TYPE P61/P61V) Model P6801H9X 86X50 cm (TYPE P91/P91V) Model P9101H9X READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE. 310693...
-
Page 2: Table Of Contents
These instructions are valid only for those countries which are indicated by their identification symbol on the front cover of the instruction booklet and on the label on the appliance. The manufacturer cannot be held responsible for any damage to things or persons caused by an incorrect installation or by incorrect use of the appliance. -
Page 3: Fixing The Hob - Advice About Installation
L1 min (cm) W (cm) D (cm) L2 min (cm) L3 min (cm) L4 min (cm) FIXING THE HOB In order to prevent liquids from accidentally leaking into the kitchen unit underneath the appliance is equipped with a special seal. To put on this seal follow the instructions below very carefully. -
Page 4: Adaptation To Different Types Of Gas
to the hotplate. The hose should not be subjected to abrasion, kinking or permanent deformation and should be able to be inspected along its entire length. Unions compatible with the hose fittings must be used and connections tested for gas leaks. The supply connection point must be accessible with the appliance installed. -
Page 5: Maintenance Of The Appliance - Replacing Parts
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. When the connection is made directly with the electricity supply: - Make sure that there is a device to disconnect the appliance from the mains with a contact opening distance sufficient for complete disconnection in category III overvoltage conditions. -
Page 6: Cleaning Of The Appliance
- Automatic Electric “On” switch: Turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is at MAXIMUM (this corresponds to a large flame) and then press in the knob. Let it go as soon as the burner is alight. - “On “... -
Page 7: Figures
Changing the parts Before carrying out any maintenance work, disconnect the appliance from the gas and electric supply. To replace different components such as burners, taps and electrical parts you must take out the hob from the kitchen unit by releasing the fixing hooks, unscrew the fixing screws of the burners on the work top, unscrew the fixing nuts of the electric plates which are visible on the lower part of the hob and remove the worktop in order to carry out the replacement of the defective parts. - Page 8 Fig.2 Fig.3 Fig.4 Fig.5A Fig.5B Fig.6A Fig.6B Fig.7 Fig. 8 Fig. 9...
- Page 9 Fig.10 Fig.11 Fig.12 Fig.13 Fig.14 Fig.15 Fig.16 Fig.17...
- Page 12 Cod. 310981...
Need help?
Do you have a question about the P6801H9X and is the answer not in the manual?
Questions and answers