MC-V5504-00 1.2. PICTORIAL DIAGRAM NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
MC-V5504-00 2 EXPLODED VIEW AND PARTS LIST 2.1. Body 2.1.1. Exploded View...
Page 6
MC-V5504-00 2.1.2. Parts List (Body) Ref. No. Part No. Part Name & Description Quantity Remarks AC88KARFZV07 Dust Compartment Includes items 38,44,45 and 46 AC98EARFZ0U ON/OFF Switch Includes items 38 and 46 AC94EAPNZY02 Power Cord Includes items 38,44,45 and 46 AMC-1CTCE23...
MC-V5504-00 2.2. Motor Fan 2.2.1. Exploded View 2.2.2. Parts List (Motor Fan Assembly) Ref. No. Part No. Part Name & Description Quantity Remarks AMC53F-AV00U Fan Case AMC33F-AC00U AMC62F-AV00U Washer AC98FRFZ00 AMC60F-AV00U Spacer AC27FRFZ00 Brush Assembly 1 (set) AC02DV3Z0U Bracket AC40DV3Z0U...
MC-V5504-00 2.4. Packing Material 2.4.1. Exploded View 2.4.2. Parts List Ref. No. Part No. Part Name & Description Quantity Remarks AC61ZCCAZOOO Packaging Assembly Includes 1 and items a-g ACO1ZCMYZOOO Operating Instructions...
MC-V5504-00 3 REPLACEMENT INSTRUCTIONS 3.1. Lower Plate 3.3. Agitator Assembly 3.1.1. Removal 3.3.1. Removal 1. Place handle in low position. 1. The brushes are not replaceable separately. When the 2. Turn the vacuum cleaner over exposing the underside. brushes need replacing, the agitator assembly will have to Release the lower plate by pressing the two (2) latches that be replaced.
MC-V5504-00 3.4. Nozzle Housing Replacement 3.4.2. Installation 3.4.1. Removal 1. Install the nozzle packing, if not already in place, window and handle release assembly in the new nozzle housing. 1. Remove the lower plate as outlined in the LOWER PLATE 2.
MC-V5504-00 3. Ensure that the insulator packing is installed correctly. 3.5. Power Cord / On-Off Switch Replacement 3.5.1. Removal 1. Remove the dust cover and switch cover to expose the electrical connections of the power cord, on-off switch and wire cord.
MC-V5504-00 3.7.2. Installation 3.9. Carbon Brush Replacement 3.9.1. Removal 1. After removing the motor, see MOTOR REPLACEMENT, make sure that you have properly indentified it. 1. Reinstall the motor protector into the dust compartment by aligning the two tabs under the top flange with the slots in the dust compartment by applying pressure from the back of the vacuum until it snaps into place.
MC-V5504-00 the fan. There is a spacer left on the motor that is not 3.10. Motor Fan required to be removed. If spacer is removed, reassemble 3.10.1. Removal per exploded view. 3.10.2. Installation 1. Mark the position of the fan case’s location on the motor with a pencil, or score it with a sharp object before 1.