Advertisement
Quick Links
Technical Data
Model
BG150
Motor
250w
Voltage
240v
No Load Speed
3450rpm
Spindle Diameter
1/2" (12.7mm)
Wheel Diameter
150mm (6")
Wheel Thickness
20mm
Net Weight
10kg
Charnwood, Cedar Court, Walker Road,
Bardon, Leicestershire LE67 1TU
Tel. 01530 516 926 Fax. 01530 516 929
email: sales@charnwood.net Website: www.charnwood.net
BG200
375w
240v
3450rpm
5/8" (15.8mm)
203mm (8")
25mm
17kg
BENCH GRINDER
OPERATING INSTRUCTIONS
Models: BG150 & BG200
Charnwood, Cedar Court, Walker Road,
Bardon, Leicestershire LE67 1TU
Tel. 01530 516 926 Fax. 01530 516 929
email: sales@charnwood.net Website: www.charnwood.net
Advertisement
Related Manuals for Charnwood BG150
Summary of Contents for Charnwood BG150
- Page 1 Model BG150 BG200 OPERATING INSTRUCTIONS Motor 250w 375w Voltage 240v 240v No Load Speed 3450rpm 3450rpm Models: BG150 & BG200 Spindle Diameter 1/2” (12.7mm) 5/8” (15.8mm) Wheel Diameter 150mm (6”) 203mm (8”) Wheel Thickness 20mm 25mm Net Weight 10kg 17kg...
-
Page 2: General Safety Rules
Light Bulb Replacement (Figure 9) GENERAL SAFETY RULES FIGURE 9 WARNING! Screws • Turn the power off and remove the plug from WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all Light Cover the outlet before replacing light bulb. instructions listed below may result in electric shock and/or serious personal injury. -
Page 3: Electrical Safety
Installing or Changing the Grinding Wheel (Figure 8) GENERAL SAFETY RULES WARNING! 20. DIRECTION OF FEED. Feed work into a blade or cutter against the direction of rotation of the • Turn the power off and remove the plug from the outlet before changing the grinding wheels. blade or cutter only. -
Page 4: Maintenance
Table 1. Minimum Gage For Power Cord Grinding Rating Total Length of cord in feet • Allow grinder to reach full speed before contacting the work piece to the grinding wheel or Volts other accessory 25 ft. 50ft 100ft 150 ft •... -
Page 5: Operation
CALIFORNIA PROPOSITION 65 OPERATION WARNING: CHEMICAL HAZARD. Use of this tool may cause exposure to chemicals that are known to the state of California to cause cancer, birth defects or other reproductive harm. WARNING! Dust and debris created during cutting, drilling, grinding or sanding on some materials may contain chemicals known to the State of California to cause cancer or birth defects or other •... - Page 6 Installing Tool Rests (See Figure 3) Figure 3 6" & 8" Bench Grinders Tool Rest 1. Unscrew and remove the carriage bolt from Thumb Knob the tool rest knob. 3X Magnifier Eye Shield Eye Shield Eye Shield 2. Attach the tool rest bracket to the inside of the Thumb Knobs wheel guard as shown.