Advertisement
TRANSMITTER
ANTENNA
Fully pull out antennas 5 and 8; adjust the antennas to be perpendicular to the
floor Antenna installation will directly affect the receiving effect.
INSTALLATlON AND USE
1.
Better keep distances between the receiver and walI
receiving signals.
2.
Don t put the receiver beside digital control equipments.
3.
Connect the receiver and tuner or corresponding amplifier inlet with audio
transmission cables, adjust the corresponding signal channeI volume knob to
get suitable audio output.
4.
Switch the power to your local operating voltage; insert the power plug into the
power socket.
5.
Switch on the power, display 3 will light up. Adjust volume knobs 2.4 to the least.
HAND-HOLD MICROPHONE
1.
Cartridge module
2.
Mic body
3.
Operating indicator
4.
Power switch
5.
Battery cover
INSTALLATION AND USE
1.
Open the battery cover 5,1.5V AA batteries for microphone. Pay attention to the
positive and negative pole signs of the batteries.
2.
Position the power switch to ON, indicator Iight 3 will be on, and indicator 10 or
15 on the receiver display will be on, showing (
frequency point 12 or 13 will also be on synchronously, indicating the receiver is
receiving effective signals from the microphone.
3.
Position the audio switch to ON, make voices toward the microphone and
adjust receiver volume control knobs 2 and 4, volume control display 9 and 15
will be on, indicating the volume you are adjusting, at the same time AF LEVEL
display 9 or 15 will dance with the music.
4.
When the power indicator darkens, it indicates lack of power. Please change
with new batteries in time.
5
To make your singing more perfect, please keep the distance between
microphone and sound source as 3-5cm.
3
floor to ensure good
1
2
3
4
5
), corresponding operating
TRANSMITTER
LAVALIER BODYPACK TRANSMITTER
Battery Cover
1.
Open the batter cover , put in 9V overlapped batteries. Pay attention to the positive
and negative pole signs of the batteries.
2.
Insert the transmitter cable and cartridge module to the cartridge socket.
3.
Position the power switch to ON, indicator light wilI be on, and indicator 9 or
16 on the receiver display will be on, showing(
frequency point 10 or 15 will also be on synchronously, indicating the receiver is
receiving effective signals from the microphone.
4.
Make voices toward the microphone, adjust receiver volume controI knobs 2 and 4,
volume control display 11 and 14 will be on, indicating the volume you are adjusting,
at the same time AF LEVEL display 12 or 13 will dance with the music.
5.
When the power indicator darkens, it indicates lack of power. Please change with
new batteries in time.
CHANGING BETTERIES
1.
The transmitter must be switched off before changing batteries.
2.
If the transmitter will not be used for a long time, please take out batteries to avoid
the parts of transmitter being destroyed by rotten batteries.
PREPARATlON BEFORE SOUND TESTlNG
1.
Make sure the frequencies of transmitter and receiver conform to each other.
2.
Keep the distance between antenna and transmitter over 1 meter.
3.
Avoid whistling, especially when using the omnidirectional microphone.
OUR SUGGESTlONS:
Decrease the system volume.
Keep the transmitter away from the speakers.
Tune down cartridge sensitivity of the transmitter.
) , corresponding operating
4
Advertisement
