Table of Contents
Advertisement
Quick Links
18 AMP-HOUR • 12 VOLT • JUMP START
OWNER'S MANUAL
WITH 120 PSI AIR COMPRESSOR • PORTABLE POWER & AIR
800 Peak Amps
• 18 Amp-Hour, 12 Volt
• 120 PSI compressor with adaptor set
• Wall charger
• 6-gauge booster cable
• Built in ultra-bright LED work light
• Safety On/Off switch
• 12 Volt cigarette lighter/charger
• Two (2) 12 Volt outlets with 15 Amp
overload protection
• Overheat protection
POWER TO GET THE JOB DONE
250-300 Normal Cranking Amps
WWW.FORNEYIND.COM
150-210 Cold Cranking Amps
• Overcharging protection
• LED battery status indicator
• Fully insulated battery clips with
600mm leads
• Robust plastic case with integral
handle
• Sealed lead-acid battery
• 1-Year/90-Day Limited Warranty
with "advanced Replacement"
52732
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Forney Jump start
Summary of Contents for Forney Jump start
- Page 1 52732 18 AMP-HOUR • 12 VOLT • JUMP START OWNER’S MANUAL WITH 120 PSI AIR COMPRESSOR • PORTABLE POWER & AIR 800 Peak Amps 250-300 Normal Cranking Amps 150-210 Cold Cranking Amps • 18 Amp-Hour, 12 Volt • Overcharging protection •...
- Page 2 “Owner manual” to confirm external-starting assistance is advised. • Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the recommended number of attempts. Discontinue jump start procedure and look for other problems that may need to be corrected.
-
Page 3: Operating Instructions
IMPORTANT - BEFORE USE Before using unit for the first time, unit must be charged for a full 26 hours. Do not exceed recommended Initial Charge Time of 44 hours. Please recharge jump starter a minimum of every 2 months. Always recharge after use. OPERATING INSTRUCTIONS 1. - Page 4 USIING POWER PORT OF JUMP STARTER 1. Remove the protective cover. 2. Plug in your 12-volt accessory. 3. There is a 15 amp automatic overload protection circuit breaker. Reset the breaker by pushing the breaker button located on the back of the jump starter. BATTERY STATUS MONITOR 1.
-
Page 5: Troubleshooting
The booster pack won't Clips are not making a good connection Check for poor connection to battery and jump start my car. to the battery. frame. Make sure connection points are clean. Rock clips back and forth for a better connection. - Page 6 Forney Industries and/or approved for use with this product. This ‘Limited Warranty” is void if the product is misused, subjected to abuse or is repaired or modified by anyone other than Forney or its authorized repair station. It is the purchaser’s obligation to read and follow the instructions provided in the owner’s manual.
Need help?
Do you have a question about the Jump start and is the answer not in the manual?
Questions and answers