NextBase Gallery 15 User Manual page 38

3. Navigate to Enter Manually, and press OK to confirm.
Change Settings
Scan for wireless networks
Wi-Fi Network
Enter Manually
Navigate to SSID, press OK to bring up the virtual
using the virtual keyboard.
Navigate to Security, and press OK
your Wi-Fi routers security method.
Navigate to IP address and DNS, and press OK to select between Dynamic and Static.
If Dynamic is selected, the information above will turn into grey.
If Static is selected, the information above will turn into white.
When Static is selected, scroll down to IP Address and press
keyboard to fill in the numbers.
After Secondary DNS is filled, the cursor will jump to Connect, and press
operation.
Note:
The IP address consists of 4 sections. The number range of each section is 0-255. If a number
over 255 is entered, it will be automatically changed to 255. Once the third digit of a section is
entered, the cursor will move to the next section automatically.
4. If the IP/DNS information is wrong, the message below will pop up.
Nextbase @Gallery 15 - User s Guide
2 00 8/1 /1 7 2 00 8/1 /1 7
0 2: 4 5
SSID
Change Settings
Wi-Fi Network Security None
Enter Manually
IP address and DNS Dynamic
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Connect
keyboard, and enter the SSID address by
to navigate from None, WEP, WPA. Select one
OK to pop up the virtual
2 00 8/1 /1 7
0 2: 4 5
Can not connect to Picasa,
please check the IP address
and DNS
,
02: 4 5
WEP WPA
Static
to match
OK to finish the
Setup 33