Table of Contents
Advertisement
3.6. Sensor Setting
1) Options
Use : When User selects this check box, the selected sensor will be enabled and used.
-
Location : User can specify the location of a sensor.
-
2) Flags
Sensor Type : According to the sensor, define the active type (high or low).
-
Selected Camera : User can configure a sensor to the specific camera.
-
3) Sensor Output
-
Use Relay Output : If User wants to send the Output, Click this check box. (Additional
equipment is required to send the Output.
-
Output Port : User can define the port that will be used to send the Output. (User can select port
1, 2, 3, 4)
Relay Time : User can define the relay time of the Output from 1 second to 10 second.(If User
-
select 5 second, the Output will be sent every 5 seconds.)
4) Sensor Test
: If you click the button of "Sensor", the system shows all setting values for the connected sensors.
When you click the button of the "Test" right upper side, it shows current active status for the each
sensor.
Users Guide
: Active
: No active
Page 23 of 98
Perpetual Digital
Advertisement
Table of Contents
