Advertisement
Troubleshooting (cont'd)
After following the setup instructions carefully, I can't get my camera to re-
spond when I trigger the (a) wireless RF remote.
- Please make sure you have properly connected the (7) connection pin into the
remote port on your camera. Try re-inserting.
- Please make sure the channels on the back of the (b) receiver and remote are set
to match.
- Your camera may have to be set into a Remote Shooting mode in the settings
menu. Please consult your User's Manual.
- Please make sure that you are fully pressing down the shutter release button so
that you see the LED glow red.
Advertisement
