Sprayer Setup - Graco 16N661 Operation - Repair - Parts

Sprayer Setup

Use only water-based materials. Do not use materi-
als which state "FLAMMABLE" on the packaging. For
more information about your material, request MSDS
from distributor or retailer.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
Your sprayer is NOT compatible with harsh cleaners
such as chlorine bleach. Using these cleaners will
cause damage to the sprayer.
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
1. Fill material cup with water or compatible solvent,
thread onto sprayer and hand tighten.
ti14992a
2. Put prime/spray valve to UP position, then hold trig-
ger in for 10 seconds.
ti16700a
10
NOTICE
ti18915a
ti14999a
3. Put prime/spray valve DOWN to spray position.
ti16701a
4. Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area for 10 seconds.
ti14777a
5. Engage trigger lock and put prime/spray valve UP to
release pressure.
ti14994a
ti18912a
6. Unscrew and remove material cup.
7. Disengage trigger lock, hold sprayer slightly above
material cup, and pull trigger to discharge fluid from
pump.
8. Discard material in cup.
Sprayer Setup
ti15425a
ti15012a
ti15491a
ti16700a
ti14999a
ti18919a
3A2854A