Table of Contents
Advertisement
o You must ensure that there is a hole to feed the electrical cable
through. If you are going to connect the appliance to your mains
water supply, then you must ensure that there is a hole to feed
the inlet hose through too. These steps must be done before
commencing the rest of the installation process.
3. Use a spirit level to make sure that the support
pieces are vertically level.
IMPORTANT: You must complete the water connection at
this stage, if you are going to connect the appliance to
your mains water supply.
2. On the marks that you have just made,
use the screws provided to fix a support
piece to either side of the housing unit.
1. Measure a height of
200 mm from the
base of the housing
unit. Then at that
height, measure out
a distance of 225
mm from the front
of it and mark it.
You should make
the same
measurement and
marking on both
sides of the housing
unit.
28
Advertisement
Table of Contents
