Advertisement
TABLE OF CONTENTS
Introduction.................................................................
Safety Alert Symbol....................................................
Important Safety Instructions.....................................
Prior to Installation......................................................
Installation of Heater...................................................
Mounting of Temperature Sensor................................
Adjustment of Temperature Set-Point.........................
Connecting Heater to AC Power.................................
Troubleshooting Guide...........................................
Warranty......................................................................
INTRODUCTION
Thank you for purchasing a OMEGALUX
heater is designed to provide a long and effi cient service life with function, reli-
ability, and safety in mind. For successful operation of these heaters, read and
understand these instructions prior to use.
SAFETY ALERT SYMBOL
The symbol above is used to call your attention
to instructions concerning your personal safety.
It points out important safety precautions. It
means "ATTENTION! Become Alert! Your
Personal Safety is involved!" Read the
message that follows and be alert to the
possibility of personal injury or death.
SAVE THESE INSTRUCTIONS!
Additional copies of this manual are available upon request.
2
© Copyright 2006 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC
2
2
3
4
4
5
5
6
7
BACK
®
Silicone Rubber Drum Heater. Your
Immediate hazards which WILL result in severe
personal injury or death
Hazards or unsafe practices which COULD result in
severe personal injury or death
Hazards or unsafe practices which COULD result in
minor personal injury or property damage.
CONNECTING HEATER TO AC POWER
SEPDH series
2. Connect the hazardous location approved plug to power source only after all
steps listed above are complete.
SHDH and SSDH without controller series
2. Refer to external temperature controller instructions for power installation
instructions.
TROUBLESHOOTING GUIDE
Please read this guide prior to contacting OMEGA. This guide is designed to
answer the most commonly asked questions. If you are unable to identify the
problem or need additional assistance, please contact us at 1-800-USA-HEAT.
PROBLEM
Does not heat
Circuit breaker is tripping
Does not fi t
Something has lightly spilled on exterior
or interior
© Copyright 2006 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC
SOLUTION(S)
Verify heater is connected to proper voltage. The
identifi cation label located on the power cord displays
the heater's voltage requirement.
Check to see if there is a resistance reading (not an
open circuit) in heater using an ohm meter.
Validate that the circuit breaker is capable of handling
the amp requirement of heater. The identifi cation
label located on the power cord displays the heater's
amperage requirement.
Examine heater and cord for any damage.
Confi rm that the heater provided was designed to fi t
around your specifi ed drum.
If the heater was designed for the specifi ed drum,
please call 1-800-USA-HEAT for further assistance.
Apply any general household cleaner, that does not
contain any silicone rubber dissolving type
ingredients, with a clean cloth fabric.
7
Advertisement
