Explanation Of Code In Remarks Column ....28 Suggested Spare Parts ..........29 Pump Assy............30-31 Specification and part number NOTE are subject to change without notice PAGE 4 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Potential hazards associated with the STOW CP-30H Centrifugal injury. Pump operation will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols. PAGE 6 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 7
ALWAYS wear approved eye and hearing protection. This pump, other property, or the surrounding environment could be NOTE damaged if you do not follow instructions. STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 7...
Multiquip for this equipment. Damage to the equipment and/or injury to user may result. ■ Manufacturer does not assume responsibility for any accident due to equipment modifications. PAGE 8 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 9
Failure to maintain water inside the pump housing will cause severe damage to the pump. ■ In winter drain water from pump housing to prevent freezing. STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 9...
Page 10
) L ( ) 6 . ( . t ) s r . n i s b l ) . g Figure 1. STOW CP-30H Dimensions PAGE 10 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 11
- y l i t r l i o t r a . n i s b l ) . g STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 11...
A , 2 ( small suction leak in the hose or fittings could prevent the pump from priming. , 3 ( PAGE 12 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
STOW CP-30H — PUMP COMPONENTS Figure 2 shows a typical application using the STOW CP-30H Centrifugal Trash pump. Please note that this pump is intended for the removal of clean water and water containing some debris and solids. Maximum size of solids should not exceed 1 inch (25 mm) in diameter.
10. Fuel Tank – Holds unleaded gasoline. For additional Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop information refer to engine owner's manual. the flow of fuel. PAGE 14 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
3. When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately! Figure 4. Engine Oil Dipstick (Removal) STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 15...
Place hose so that it lays as straight as it is possible on the ground. Remove any twists or sharp bends from hose which may block the flow of water. PAGE 16 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
5. Place the engine ON/OFF switch (Figure 10) in the " ON " position. Figure 7. Throttle Lever (1/3 Start Position) Figure 10. Engine ON/OFF Switch (ON Position) STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 17...
Page 18
Emergency Showdown 1. Move the throttle lever quickly to the IDLE position, and place Figure 13. Throttle Lever (Run) the engine ON/OFF switch in the OFF position. PAGE 18 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 20
This prevents backflow and allows for faster priming when the engine is restarted. PAGE 20 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 21
STOW CP-30H — MAINTENANCE (PUMP) Pressure reading may vary depending on altitude. See Tables 3 NOTE and 4 on page 12. Figure 17. Pump Vacuum Tester STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 21...
Page 22
. s l Reference manufacturer engine NOTE manual for specific servicing instructions. PAGE 22 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
(new or used) through the discharge opening on the pump and crank the engine several times. This will prevent excessive corrosion and also keep the mechanical seal lubricated. PAGE 24 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
>, belong to the same assembly or kit. If more than one of the same reference number is listed, the NOTE last one listed indicates newest (or latest) part avaliable. PAGE 28 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
2 .... 0481310250 ..O-RING, FLOODING CAP Part number on this Suggested Spare Parts List may super cede/ NOTE replace the P/N shown in the text pages of this book. STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 29...
Page 37
SCREW, PAN (3 X 6) 9430520122 PIN, SPRING (2 X 12) 99101ZH80650 JET, MAIN (#65) OPTIONAL 99101ZH80680 JET, MAIN (#68) OPTIONAL 99101ZH80700 JET, MAIN (#70) 99204ZE00350 JET, SET, PILOT (#35) STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 37...
Page 38
HONDA GX160K1TX2 ENGINE — CONTROL ASSY. CONTROL ASSY. PAGE 38 — STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)
Page 39
SPRING, CONTROL ADJUSTING 90013883000 BOLT, FLANGE (6 X 12) (CT200) 90015ZE5010 BOLT, GOVERNOR ARM 90114SA0000 NUT, SELF-LOCK (6MM) 93500050250A SCREW, PAN (5 X 25) 9405006000 NUT, FLANGE (6MM) STOW CP-30H CENTRIFUGAL PUMP — PARTS MANUAL— REV. 0 (05/30/03) — PAGE 39...
Need help?
Do you have a question about the CP-30H and is the answer not in the manual?
Questions and answers