MTD Series 520 Operator's Manual page 10

6
Making
Adjustments
WARNING
Rotating cutting blade
may throw objects
causing personal
injury. Keep area clear
of bystanders and do
not operate without
guards in place.
Bevel Adjustment
NOTE: Edger features vary by model. All edger models
do NOT come equipped with a bevel adjustment nor
is there a bevel adjustment kit available to modify your
edger if it was not purchased equipped to do so.
The angle of the edger blade can be adjusted by placing
the bevel adjustment in one of three positions for edging
or beveled edging. See Figure 7.
Bevel Adjustment
Lever
Edging Position
Shown
Figure 7
WARNING: Rotating cutting blade may
throw objects causing personal injury.
Keep area clear of bystanders and do
not operate without guards in place.
Beveling
In order to achieve a bevelled edge, set the bevel
adjustment lever (refer to Figure 7) in the first (left hand)
or third (right hand) notch to place the edger blade in
position for beveling. See positions below in Figure 8.
Left Hand Position
Beveled Edging Positions
Figure 8
NOTES:
Right Hand Position
10