Lanzar Vector VCTBS8 Owner's Manual

Mounting the subwoofer
1. Find a suitable location in the vehicle in which to mount the amplifier.
A typical location is shown below:
2. Make sure there is sufficient air circulation around the intended mounting location.
3. Mark the location for mounting hole screws by positioning the cabinet where you
wish to install it. Make a small mark to identify the position and remove the unit.
Thoroughly clean the area you plan to attach the subwoofer, using a vacuum cleaner.
Then attach the supplied double adhesive tape, and put the subwoofer in the place
and press down on it securely.
Troubleshooting
If you experience operation or performance problems with this product, compare your
installation with the electrical wiring diagram on the previous pages. If problems
persist, read the following troubleshooting tips which may help eliminate the problems.
PROBLEM POSSIBLE REASON
SOLUTION
• N0+12v
to
povver
wire
• Check fuses and connections to battery
Not switching on. Power • No
povver to remote
wire
• Check remote on connections to head unit
LED not 'on'
• Fuse broken
• Replace fuse with correct type and
amperage
• Fuse bIcMIn
• Replace fuse with correct type and
Not working, but status
amperage
LED 'on'
• Move unit to vented area
• Amplifier too hot
• Turn head unit down
No sound
• Head Unit
• Check heed unit volume level
• Gain
oontroI
not
set
up
• Ensure you have set up the amplifier
gain level control
• Connections
• Check all power, remote on and ground
connections
www.lanzar.com
VCTBS8
8" Super Slim
Active Subwoofer
OWNER'S MANUAL