Trouble Shooting; Basic Operation; Source On/Off; Playing Source Choose - Booster BDVM-8490MPBTV Instruction Manual

INSTRUCTIONS

TROUBLE SHOOTING

PROBLEM CAUSE
Check whether power fuse
blew or not
Can not power on
Some factor cause MPU wrong
operation
Wrong connection between
After ignition
switch off, setting
ignition line ACC and
information all lose
Constant 12 Volt wire
Remote control no
No enough power supply
function
from battery
Improper length of antenna,
Poor performance
poor connection of antenna
of radio station
grounding
The disc will not go in all
Can not load disc
the way
Disc is scratched
Put wrong side of disc into unit
Can not play disc
Lens has dirty
Can not switch
There is only one language/
language/subtitle
subtitle in disc
Video line between unit and
No image
TV is not properly connected
SOLUTION
Change fuse same as the old one
Press RESET button on the panel by pen
point, then, power on
Change the wiring around
Change battery in remote control
Check whether antenna is connected or not,
or poor connection
Remove the 2 screws on top of the radio
Change new disc
Slot in the disc with sign side up
Clean lens by lens clean disc
If disc is not with multi-language/subtitle, it
cannot switch language/subtitle
Reconnect lines

BASIC OPERATION

1. SOURCE ON/OFF

Press SRC button on panel or PWR button on remote control quickly to power on.
Press SRC button on panel or PWR button on remote control longer to power off.

2. PLAYING SOURCE CHOOSE

Press SOURCE button on remote control, unit will switch sources in the following
sequence: RADIO → DVD → AUX →TV→GPS
3. MUTE CONTROL
Press MUTE button on panel or MUTE button on remote control shortly to turn off
sound output, press again to back to sound output.
4. VOLUME ADJUSTMENT
1) Press VOL+/VOL- button on panel, VOL+/VOL- button on remote control or touch
button on display to adjust volume level.
2) The volume setting on this unit is 0 - 39.
TONE MODE ADJUSTING (SEL)
Press SEL button on remote control or SEL button on the panel to choose your desired
tune mode:
VOL → BAS → TRE → L/R → F/R
NOTE:
1) DVD playing mode, MBP & User will be automatically activated.
2) After 5 seconds you choose desired mode, do not adjust volume button. The mode
will automatically take you back to status before adjustment.
5. RESET
1) If unit is not working correctly, you should press the RES button. This will reset the
radio and should start working correctly afterwards.
2) After reset, all settings will resume back to the factory default settings.
INSTRUCTIONS