Pressure Switch - DeWalt D55150 Instruction Manual

PUMP CYLINDER
HOT SURFACES
PUMP
HEAD
AFTERCOOLER
on compressor during or immediately after operation.
Compressor will remain hot for several minutes after
operation. Do not move the compressor while it is
running. Hot motor parts could cause burns contributing
to the dropping of the compressor, damaging the
compressor and/or injuring the operator.
RISK FROM NOISE
C A U T I O N : Wear appropriate personal hearing
protection during use. Under some conditions and
duration of use, noise from this product may contribute to
hearing loss.
Introduction
Congratulations on the purchase of your new D
Compressor! You can be assured that this tool has been constructed
with the highest level of precision and accuracy. Each component
has been rigorously tested by technicians to ensure the quality,
endurance and performance of this air compressor.
By reading the following simple safety, installation, operation,
maintenance and troubleshooting steps described in this manual,
you will receive years of trouble-free operation.The manufacturer
PUMP
HEAD reserves the right to make changes in price, color, materials,
equipment specifications, or models at any time without notice.
Inspection of Compressor
Inspect for signs of obvious or concealed freight damage. Report any
damage to the delivering freight carrier immediately. Be sure that all
damaged parts are replaced and any mechanical problems are
corrected prior to the operation of the air compressor. The air
compressor serial number is located on the shroud of the
c o m p r e s s o r. Please write the serial number in the space provided in
the service section for future reference.
WA R N I N G : When using electric tools, basic safety precautions
should always be followed to reduce risk of fire, electric shock, and
personal injury.
D WALT Air Compressor Features
E

PRESSURE SWITCH

This switch (A) is used to start or stop the air compressor. Moving the
switch to the O N position will provide automatic power to the
pressure switch which will allow the motor to start when the air tank
pressure is below the factory set cut-in pressure. When in the O N
( A U TO ) position, the pressure switch stops the compressor from
charging air when the air tank pressure reaches
the factory set cut-out pressure limit. For ease of
starting, this switch also has a pressure release
valve located on the side of the switch designed
WA LT A i r
E
to automatically release compressed air from
the air compressor pump head and its discharge
line when the air compressor reaches the cut-
out pressure limit or is shut off. Moving the
switch to the O F F position will open the
4
B
A